![putput :putput:](./images/smilies/34o9cv5.jpg)
1400 Neutral difficulty
-
- Riding on Learners Permit
- Posts: 185
- Joined: Sun Oct 15, 2017 8:21 am
- My Bike: 1996 Suzuki Intruder 1400
1400 Neutral difficulty
When my 1400 is sitting still running ,. Is Neutral had to find on these bikes,.? Or is there an adj. for this,. ? Thks Just got this bike done,. ![putput :putput:](./images/smilies/34o9cv5.jpg)
![putput :putput:](./images/smilies/34o9cv5.jpg)
-
- Joined a 1000cc Club
- Posts: 3967
- Joined: Tue Dec 09, 2014 9:58 pm
- My Bike: VS800 Honda Phantom 200
Re: 1400 Neutral difficulty
Give the linkage a good coat of PB or WD.
When the engine oil gets ready for a change it does effect the shifts.
[emoji41]
When the engine oil gets ready for a change it does effect the shifts.
[emoji41]
Grow old disgracefully young man.
- WintrSol
- Joined a 450cc Club
- Posts: 857
- Joined: Fri Feb 26, 2016 2:02 pm
- My Bike: CB450 GL1500CT
- Location: Near St. Louis, MO
Re: 1400 Neutral difficulty
While cleaning/lubing the linkage, check to see if it needs adjusting, too.
Florissant, MO
CB450K3, GL1500CTValkyrie
CB450K3, GL1500CTValkyrie
-
- Back on the Road
- Posts: 3565
- Joined: Tue Dec 09, 2014 5:07 pm
- My Bike: 650Vstrom
Re: 1400 Neutral difficulty
Any bikes you have with the joints covered with the small rubber covers need lube. If riding on salt covered roads,often.Make a tool from a small paper clip. Bend up a bit of one end to lift rubber cover.Stick a nozzle end in and spray a hit of your choice of lube in a can. My usual is white grease. On old trade inbikes with rust PB blaster may be needed. Good luck and wear out dont let them rust out.
-
- Got My M1 License!
- Posts: 433
- Joined: Wed Feb 24, 2016 2:54 pm
- My Bike: 1992 Intruder 1400
Re: 1400 Neutral difficulty
My 92 Intruder 1400 always had a difficult time going to neutral. It was often a lot easier just to tap it down from second then pop it up from first
- DrAlloway
- Studying MC Handbook
- Posts: 65
- Joined: Tue Mar 17, 2015 2:48 pm
- My Bike: vs1400 Intruder
Re: 1400 Neutral difficulty
In addition to lubing the linkage
also
where linkage emerges from the engine casing >> these parts should be flush with casing. They tend to wiggle out a bit. Tap them back in with a block of wood.
also
where linkage emerges from the engine casing >> these parts should be flush with casing. They tend to wiggle out a bit. Tap them back in with a block of wood.