Page 1 of 1
Intruder dyna 3000
Posted: Fri Jul 30, 2021 6:43 pm
by 94 intruder
In have a question about a 94 intruder 1400 i have a 8 pin and a 4 pin cdi I had to buy a dyna 3000 because they don't make this part anymore. I can seem.to.get it to start now I've tried all the settings and nothing has anyone had any luck with these cdi reason in had to replace it that I dropped the seat and ripped it off the back if it lol
Re: Intruder dyna 3000
Posted: Sat Jul 31, 2021 5:47 am
by Designer
I've opened the Stock Transistorized Ignitor ( it's not Capacitive Discharge Ignition as so often thought it is ) and it still worked.
Have you tried using the Stock one that was opened to see it is not damaged?
Re: Intruder dyna 3000
Posted: Mon May 01, 2023 9:34 pm
by Babz
Is there any chance you could post a picture of the internals of the stock igniter for me? I lost a small resistor on the board while trying to find a pair of transistors to replace the burnt out d1071’s and I can’t figure out what the ohm rating was supposed to be on it I have the 1987 igniter
Re: Intruder dyna 3000
Posted: Tue May 02, 2023 5:15 am
by Designer
Hi Babz!
Wellsir,...I went through all my Customizing/Chopper pictures and I do not have any of the inside of the TCI.
So sorry.
