1996 and 1995 VS1400 Complete Partouts

[Polkahero]

I just recently parted out two VS1400 models. Black/red 1995 model and a teal/white 1996 model. 95 powered up and turned over, good engine compression. I was unable to power up the 96 model but I tested most of the components on a running 96 model. Seat and sissy bar on the 96 model are Harley parts, won't fit any stock VS1400 models. Let me know what you're looking for and I'll reply back with prices and availability. Bikes pictured below.

[BRONX INTRUDER]

condition of tanks and prices? Also seat on black?

[Polkahero]

condition of tanks and prices? Also seat on black?

Just noticed this, don't get notifications of replies. Teal tank is sold, black is still available. $300 USD plus shipping. Has a few minor dents and is clean inside.
I kept the driver portion of the seat on the black bike for another project. Passenger portion is available.

[Acton67]

Looking for a new starter switch, any pictures?

[Pvt_Nemesis]

I think the freight might kill me but how much for the front disc/rotor to Christchurch, New Zealand? Also lower triple tree and steering stem?

[navigator]

Looking for a new starter switch, any pictures?

I think the freight might kill me but how much for the front disc/rotor to Christchurch, New Zealand? Also lower triple tree and steering stem?

You guys would do better to PM or email him.
It appears he is not monitoring his thread.

[BRONX INTRUDER]

I think the freight might kill me but how much for the front disc/rotor to Christchurch, New Zealand? Also lower triple tree and steering stem?

Thought you asked about a 21" front rim too.. This has a lip so probably no good unless you or someone you know can fix it. I probably have stems but the lowers on them aren't in good condition. I'll have to keep looking.

[Pvt_Nemesis]

Thanks Bronx, yeah i did say a 21" but I hadn't heard back so threw a new tire on (and the clowns must have dropped it and bent the disc) to go for a ride before winter comes.

Still keen to price the stem/triple tree but might have pressed the disc straight. A 21" depends on cost and spousal approval.

[BRONX INTRUDER]

Thanks Bronx, yeah i did say a 21" but I hadn't heard back so threw a new tire on (and the clowns must have dropped it and bent the disc) to go for a ride before winter comes.

Still keen to price the stem/triple tree but might have pressed the disc straight. A 21" depends on cost and spousal approval.

Kool beans. Haha.

[Pvt_Nemesis]

I probably have stems but the lowers on them aren't in good condition. I'll have to keep looking.

If the lowers are that bad i could look at getting it re-chromed, if it works out cheap enough? Or press out the stems and swap (when replacing the bearings i discovered mine has cuts from PO removing lower bearing)

[Polkahero]

Looking for a new starter switch, any pictures?

I think the freight might kill me but how much for the front disc/rotor to Christchurch, New Zealand? Also lower triple tree and steering stem?

You guys would do better to PM or email him.
It appears he is not monitoring his thread.

I don't get notifications from this site!

[Polkahero]

Looking for a new starter switch, any pictures?

You mean the right handlebar controls, correct?

[Polkahero]

condition of tanks and prices? Also seat on black?

Both fuel tanks are sold. I'm keeping the driver portion of the black seat for another project, passenger portion is still available.

[navigator]

Looking for a new starter switch, any pictures?

I think the freight might kill me but how much for the front disc/rotor to Christchurch, New Zealand? Also lower triple tree and steering stem?

You guys would do better to PM or email him.
It appears he is not monitoring his thread.

I don't get notifications from this site!

You will not get notification if someone posts to your thread.
You will, however, get notification if someone quotes you.

[The1Chef]

Still got a harness for a 96 1400?

[navigator]

Let me know what you're looking for and I'll reply back with prices and availability.

Still got a harness for a 96 1400?

[hillsy v2]

You will not get notification if someone posts to your thread.
You will, however, get notification if someone quotes you.

You will (should) get notifications of any new posts if you have subscribed to the thread:

[sgtcall]

At the top left of the page go to You Posts to find the topics you have posted in. The ones that have been updated will have the bold circle.

[TheNicestPeople]

i need a set of drivers foot pegs! PM me if you have em

[sgtcall]

i need a set of drivers foot pegs! PM me if you have em

You may want to send him an email.