New member

Tonka2240 · Post by **Tonka2240** » Mon Sep 25, 2023 8:52 am

I ride a 2001 Suzuki intruder vl1500.
When I pull in the clutch and put it in 1st it stalls.

Designer · Post by **Designer** » Mon Sep 25, 2023 10:09 am

Welcome!...New Member!

Glad you are here!

I'll wager the issue is with your Hydraulic System.

Have you checked the fluid level lately?

Is the Fluid dark?

If it is,...I suggest you Bleed-in all new Fluid.
Not necessarily draining it first..... let the New Clean Fluid "flush" the system clean.

Here's a method to make sure all the teeny-tiny micro-bubbles are gotten out;
viewtopic.php?f=10&t=4

sgtcall · Post by **sgtcall** » Mon Sep 25, 2023 10:44 am

Welcome!
Here are a couple of things to check out.

INTRUDER MANUALS AND INFORMATION
viewtopic.php?f=19&t=14168

POSTING PICTURES ON INTRUDERS ALERT
viewtopic.php?f=19&t=13992

sgtcall · Post by **sgtcall** » Mon Sep 25, 2023 10:49 am

Tonka2240 wrote: ↑
Mon Sep 25, 2023 8:52 am
I ride a 2001 Suzuki intruder vl1500.
When I pull in the clutch and put it in 1st it stalls.

Did you do any recent work on the bike?
How old is the clutch fluid?
Check the slave cylinder to make sure it is clean and has a good seal.
Check the master cylinder for leaks. If it is original you can order a rebuild kit for about $30 on amazon. The seals in the MC tend to go bad over time and allow air into the system.

navigator · Post by **navigator** » Mon Sep 25, 2023 11:11 am

Tonka2240 wrote: ↑
Mon Sep 25, 2023 8:52 am
I ride a 2001 Suzuki intruder vl1500.
When I pull in the clutch and put it in 1st it stalls.

Is your kickstand up?
It will shut off in gear with the kickstand down.

sgtcall · Post by **sgtcall** » Mon Sep 25, 2023 11:15 am

navigator wrote: ↑
Mon Sep 25, 2023 11:11 am

Tonka2240 wrote: ↑
Mon Sep 25, 2023 8:52 am
I ride a 2001 Suzuki intruder vl1500.
When I pull in the clutch and put it in 1st it stalls.
Is your kickstand up?
It will shut off in gear with the kickstand down.

Good point. Could a bad kick stand switch cause that also?

navigator · Post by **navigator** » Mon Sep 25, 2023 1:24 pm

hillsy v2 · Post by **hillsy v2** » Mon Sep 25, 2023 2:47 pm

I had the stand get tight on the pivot with mine once - went over a speed bump a little fast and the stand swung down a bit and stayed there. Bike cut out and I cruised to a stop. Took a little while to work that out but check your stand is going up fully and the switch is engaging / working.

sgtcall · Post by **sgtcall** » Mon Sep 25, 2023 6:31 pm

So the other question is how does it stall? If it surges foward a little then stalls I'd say it is the clutch or clutch fluid. If it just cuts off it's the kick stand switch.

azazelakira · Post by **azazelakira** » Wed Sep 27, 2023 1:56 am

Welcome to the forum!

Designer · Post by **Designer** » Wed Sep 27, 2023 7:03 am

He's been back here on the 26th. Odd that he hasn't responded to the several suggestions made on the 25th.

hillsy v2 · Post by **hillsy v2** » Wed Sep 27, 2023 5:32 pm

Probably just got his answer and left.

Suzuki Johnny · Post by **Suzuki Johnny** » Mon Oct 09, 2023 7:03 am

Welcome to the board.
Ride Safe and Post often

Intruders-Alert

New member

New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member

Re: New member