Hello from Montgomery, AL
Posted: Mon May 18, 2020 5:01 pm
Hi Everyone.
I ran across a 99 VS1400 the last week of Feburary that was in storage for 2 years or so. I took the plunge and offered the Owner $500.00 and he loaded it for me. The tank was rusted, the gas smelled like 2 year old gas and brother, she was a orphan. Dirty, stale, and mad.
So two carb rebuilds, stage kit's, tank liner, KN filters, flush the final drive, flush the oil, flush the clutch, flush the brakes, new fuel lines, added fuel filter's, chrome polish, elbow grease, beer---a lot of beer, cussing, stalking this site looking for tips, she is alive! Just over 13k miles and she is loved.
Side note: I'm a plumber and took small engine repair during high school. All it took was love, beer and taking advice. I have the video when she first started up, but I can't upload it. It took a few months of weekend / a few hours a week at night work.
How I re-packed everything under the tank, well, I didn't use a hammer, but I had one on stand-by.
Thanks,
Charlie
p.s. anyone know a good aftermarket site? Forward controls or floor boards?
Edit... the video
I ran across a 99 VS1400 the last week of Feburary that was in storage for 2 years or so. I took the plunge and offered the Owner $500.00 and he loaded it for me. The tank was rusted, the gas smelled like 2 year old gas and brother, she was a orphan. Dirty, stale, and mad.
So two carb rebuilds, stage kit's, tank liner, KN filters, flush the final drive, flush the oil, flush the clutch, flush the brakes, new fuel lines, added fuel filter's, chrome polish, elbow grease, beer---a lot of beer, cussing, stalking this site looking for tips, she is alive! Just over 13k miles and she is loved.
Side note: I'm a plumber and took small engine repair during high school. All it took was love, beer and taking advice. I have the video when she first started up, but I can't upload it. It took a few months of weekend / a few hours a week at night work.
How I re-packed everything under the tank, well, I didn't use a hammer, but I had one on stand-by.
Thanks,
Charlie
p.s. anyone know a good aftermarket site? Forward controls or floor boards?
Edit... the video