Page 1 of 1

Source for turn signal rubber mount?

Posted: Mon Aug 22, 2016 5:28 pm
by Joe A
Does anyone know where I can find just the rubber mount for the rear turn signals? Both of mine are cracked (currently held together with gorilla tape) and the stealership only sells the whole assembly.

Image

Re: Source for turn signal rubber mount?

Posted: Mon Aug 22, 2016 5:35 pm
by enforcer
I have a few laying around. They look the same. You can have them for the cost of shipping. Shouldn't be much since, IIRC, you're down in KC?

Re: Source for turn signal rubber mount?

Posted: Mon Aug 22, 2016 5:50 pm
by enforcer
And I just looked, and they're not the same part number but they look exactly alike. I suspect the part number is different because of the connector for the receptacle.

Re: Source for turn signal rubber mount?

Posted: Mon Aug 22, 2016 6:39 pm
by Joe A
That would be awesome! I can paypal you, or email you a priority mail label - whatever would be easier.

Re: Source for turn signal rubber mount?

Posted: Mon Aug 22, 2016 7:08 pm
by enforcer
Joe A wrote:That would be awesome! I can paypal you, or email you a priority mail label - whatever would be easier.
Let me take a pic when I get home so I can show you exactly what they look like. I still have all four, I can remove the rubbers and throw them in an envelope, since I have some errands to run tomorrow morning anyway. Just shoot me an address.

Re: Source for turn signal rubber mount?

Posted: Tue Aug 23, 2016 10:37 am
by enforcer
Here's what they look like.
Image
That's what you're looking for, correct?

Re: Source for turn signal rubber mount?

Posted: Tue Aug 23, 2016 3:28 pm
by Joe A
That's them for sure! I'll PM you my address. let me know what you need to cover postage.

Thanks!

Re: Source for turn signal rubber mount?

Posted: Tue Aug 23, 2016 4:36 pm
by enforcer
Joe A wrote:That's them for sure! I'll PM you my address. let me know what you need to cover postage.

Thanks!
PM sent.

Re: Source for turn signal rubber mount?

Posted: Fri Aug 26, 2016 12:29 pm
by Joe A
Just got them today, thanks!

Now, I'm trying to figure out how to replace the damn things without cutting and splicing the wires. I don't see where they disconnect, unless it's the rubber boot where the wires go into the lamp housing.

Re: Source for turn signal rubber mount?

Posted: Fri Aug 26, 2016 1:25 pm
by Joe A
Okay. I'm just thick. You've gotta take the mounting bracket off.

I find it curious that, instead of drilling and tapping one extra hole so that these could be used on either side, they make suzuki dealers stock a dedicated left and right version.

Re: Source for turn signal rubber mount?

Posted: Fri Aug 26, 2016 7:13 pm
by enforcer
Joe A wrote:Okay. I'm just thick. You've gotta take the mounting bracket off.

I find it curious that, instead of drilling and tapping one extra hole so that these could be used on either side, they make suzuki dealers stock a dedicated left and right version.
Tell me about it.

In order to remove my stock signals it was one screw a piece at the signals and unplug under the seat and headlight housing.

I'm just curious to make sure they fit. [emoji106]

Re: Source for turn signal rubber mount?

Posted: Fri Aug 26, 2016 9:27 pm
by Joe A
Yep, they fit great, thanks!