Driveshaft / final drive angle

[Chaulkboard]

So I hardtailed my 03 vs800 and am afraid I went a bit too steep on the angle with the shaft. Can anyone point me in the right direction or give me some info on what the Max angle I can have on the shaft. I'm not having any bad vibrations when I shift it through the gears when I have it up on my table, but want to have some knowledge on this before I put it on the road. Thanks!

[hillsy v2]

Post some pics so we can see what you're worried about.

[Chaulkboard]

I'm trying to figure out how to post pics, hopefully get some up soon.

[hillsy v2]

You need to link via an image hosting site - this forum doesn't host pics.

Postimages, Imageshack, IMGBB, etc.

[Chaulkboard]

https://postimg.cc/BL0P0Jyt

I hope this helps, this is the only pic I have right now, I can get more later when I'm home.

[hillsy v2]

https://postimg.cc/BL0P0Jyt

I hope this helps, this is the only pic I have right now, I can get more later when I'm home.

You have to paste the hotlink for the forum:

[Chaulkboard]

https://postimg.cc/BL0P0Jyt

I hope this helps, this is the only pic I have right now, I can get more later when I'm home.

You have to paste the hotlink for the forum:

Oh, thank you,

[hillsy v2]

BTW - angle doesn't look dangerous to me. Probably no worse than under full suspension compression on a stock set up.