Page 1 of 1
new clutch
Posted: Mon Jan 22, 2018 9:37 am
by mikeman3
at this point its obvious that i need to get my springs from designer but who makes a good set of clutch plates and steels
Re: new clutch
Posted: Mon Jan 22, 2018 9:52 am
by navigator
EBC
Re: new clutch
Posted: Mon Jan 22, 2018 7:40 pm
by Herb
Are you certain you need new plates and steels? Lot of money if you don't need them.
At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
Re: new clutch
Posted: Tue Jan 23, 2018 4:21 am
by theMKoi
Herb wrote:Are you certain you need new plates and steels? Lot of money if you don't need them.
At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
1+
My bike appeared to have turbo lag while passing. I installed Designer Springs and now it pulls hard. 58 000 Kms. Double check your wear before you go buy some.