new clutch

Post Reply
mikeman3
Tricycles are Cool
Posts: 5
Joined: Fri Aug 04, 2017 1:51 pm
My Bike: 03 1400 intruder

new clutch

Post by mikeman3 »

at this point its obvious that i need to get my springs from designer but who makes a good set of clutch plates and steels

navigator
Joined a 1100cc Club
Posts: 5431
Joined: Thu Dec 29, 2016 12:33 pm
My Bike: VS800

Re: new clutch

Post by navigator »

EBC

User avatar
Herb
Joined a 1200cc Club
Posts: 19126
Joined: Sun Oct 26, 2014 9:28 pm
My Bike: 1999 1400 intruder

Re: new clutch

Post by Herb »

Are you certain you need new plates and steels? Lot of money if you don't need them.

At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
I can't seem to win the lottery. I think I have used up all of my good luck riding motorcycles.

theMKoi
Tricycles are Cool
Posts: 13
Joined: Wed Jun 29, 2016 6:36 pm
My Bike: 1997 Suzuki Intruder 1400
Location: G.T.A.

Re: new clutch

Post by theMKoi »

Herb wrote:Are you certain you need new plates and steels? Lot of money if you don't need them.

At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
1+

My bike appeared to have turbo lag while passing. I installed Designer Springs and now it pulls hard. 58 000 Kms. Double check your wear before you go buy some.
Thanks,

Matt


'97 Intruder 1400

:hahafinger:

Post Reply