new clutch
-
- Tricycles are Cool
- Posts: 5
- Joined: Fri Aug 04, 2017 1:51 pm
- My Bike: 03 1400 intruder
new clutch
at this point its obvious that i need to get my springs from designer but who makes a good set of clutch plates and steels
-
- Joined a 1100cc Club
- Posts: 5431
- Joined: Thu Dec 29, 2016 12:33 pm
- My Bike: VS800
Re: new clutch
EBC
- Herb
- Joined a 1200cc Club
- Posts: 19128
- Joined: Sun Oct 26, 2014 9:28 pm
- My Bike: 1999 1400 intruder
Re: new clutch
Are you certain you need new plates and steels? Lot of money if you don't need them.
At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
I can't seem to win the lottery. I think I have used up all of my good luck riding motorcycles.
-
- Tricycles are Cool
- Posts: 13
- Joined: Wed Jun 29, 2016 6:36 pm
- My Bike: 1997 Suzuki Intruder 1400
- Location: G.T.A.
Re: new clutch
1+Herb wrote:Are you certain you need new plates and steels? Lot of money if you don't need them.
At 35,000 my clutch was slipping bad, for the 3rd time, pulled the plates and they measured well above the minimums, installed Designer's springs and never had another problem.
My bike appeared to have turbo lag while passing. I installed Designer Springs and now it pulls hard. 58 000 Kms. Double check your wear before you go buy some.
Thanks,
Matt
'97 Intruder 1400
Matt
'97 Intruder 1400