Well not me obviously
So here's the deal, I own a -96 1400.
Last year it died while riding. Long story short i have replaced the fuel pump and the fuel pump relay. The carbs are clean. This happened this weekend with only 3-400 miles on the new pump. Bike dies and the pump refuses to prime. Completely dead. Apparently something is feeding impulses to the pump. Don't know what.
Anyone else had this issue?
Dying while riding
-
- Tricycles are Cool
- Posts: 2
- Joined: Mon May 29, 2023 12:32 pm
- My Bike: 1996 vs1400
-
- Joined a 1100cc Club
- Posts: 5496
- Joined: Thu Dec 29, 2016 12:33 pm
- My Bike: VS800
- hillsy v2
- Bike out of hock
- Posts: 3042
- Joined: Wed Jul 27, 2022 5:35 pm
- My Bike: Too many to list
Re: Dying while riding
There is a relay that controls the fuel pump and it is a known issue that it can play up.
You can bypass the relay and wire the fuel pump into the orange / white wire that comes from the kill switch (it also goes into the ignitor). That way you have the pump power on when the kill switch is on and no relay.
You can bypass the relay and wire the fuel pump into the orange / white wire that comes from the kill switch (it also goes into the ignitor). That way you have the pump power on when the kill switch is on and no relay.
-
- Tricycles are Cool
- Posts: 2
- Joined: Mon May 29, 2023 12:32 pm
- My Bike: 1996 vs1400
Re: Dying while riding
Thank you the replies.
As stated above, both relay and pump are new as of 400 miles give or take. Done the whole bypass before, rode around with a piece of cable in my pocket just waiting for the relay to conk out.
What I want to do now is delve deeper and find out what causes these problems. Something is obviously "eating" parts.
As stated above, both relay and pump are new as of 400 miles give or take. Done the whole bypass before, rode around with a piece of cable in my pocket just waiting for the relay to conk out.
What I want to do now is delve deeper and find out what causes these problems. Something is obviously "eating" parts.
- Herb
- Joined a 1200cc Club
- Posts: 19279
- Joined: Sun Oct 26, 2014 9:28 pm
- My Bike: 1999 1400 intruder
Re: Dying while riding
The way you put this it appears it is the relay that has caused the problem. I would verify the wiring to the relay is good and that the signal (ground) from the ign box is not being interupted.Andreas Roth wrote: âTue May 30, 2023 11:42 pmThank you the replies.
As stated above, both relay and pump are new as of 400 miles give or take. Done the whole bypass before, rode around with a piece of cable in my pocket just waiting for the relay to conk out.
What I want to do now is delve deeper and find out what causes these problems. Something is obviously "eating" parts.
Personally, the relay went bad on mine years ago, jumpered the connector, threw the relay away and haven't had an issue since.
I can't seem to win the lottery. I think I have used up all of my good luck riding motorcycles.
-
- Joined a 1100cc Club
- Posts: 5496
- Joined: Thu Dec 29, 2016 12:33 pm
- My Bike: VS800
Re: Dying while riding
Also check the voltage output of the regulator. You may be overcharging your entire system.